Occasionally customers ask questions about their water as a result of some change in its taste, smell or appearance. These characteristics are not usually related to health effects but do affect the aesthetic and perceived-health quality of the water. In any case, these characteristics are of concern to the Water Works Department, as well. Following are some descriptions that may be helpful in answering your questions about water changes.
Yes. The City of Columbia fluoridates its water in accordance with S.C. DHEC and U.S. EPA recommendations. Current levels of fluoridation can always be found in the City's most recent Consumer Confidence Report in English and español . For details on fluoridation in South Carolina, see S.C. DHEC's Fluoridation: Nature's Way to Prevent Tooth Decay.
The City of Columbia Water Works Division fluoridates the water in all of its treatment facilities to provide an optimal level of fluoride for protection against tooth decay. Fluoride is provided at a level just under the current EPA recommended minimum of 0.7 milligrams per liter.
Cloudy water is usually caused by tiny air bubbles in the water similar to gas bubbles in carbonated drinks. This usually happens during winter months when air gets mixed into the cold water and then the water is warmed as it sits in household plumbing or hot water heaters. Cold water can hold more air than warm water. When the warmed water is released from a faucet into a glass, the air bubbles rise to the top and the water clears. There is no health risk associated with air in water.
Air can also occur in water after routine repairs to waterlines. If the air does not clear up or if it seems excessive, contact the City of Columbia Customer Care Center at (803) 545-3300.
We are required by law to provide disinfectant (chlorine) residuals to the taps of our customers to protect the water from harmful bacteria. This may mean that you encounter chlorine-type tastes and odors from time to time. If you find these objectionable, fill a container with water and store it in the refrigerator for drinking. Leave the cap slightly loose and most of the chlorine smell should dissipate.
You can also use a hand-held pitcher with an activated carbon filter to remove chlorine, or install a point-of-use water treatment device on a faucet for your cooking and drinking water. Be certain that the device has been tested by an independent organization for aesthetic (non-health) use. ANSI/NSF Standard 42 establishes minimum requirements for materials, design and construction, and performance of drinking water devices that reduce specific aesthetic-related contaminants in public or private water supplies. These products usually contain activated carbon that can remove many chemicals that affect taste and odor, including chlorine.
Point of use devices contain filter cartridges that must be changed out periodically. Be sure to follow manufacturer's recommendations to replace the cartridges. If you plan to store water from these devices, treat the water as a food product, and use clean, airtight containers and refrigerate, as the water is no longer protected from bacteriological contamination. For more information about filters, see the Home Filtration section of this FAQ.
The City began using chloramine in addition to chlorine as a disinfectant at its Columbia Canal Water Treatment Plant in the mid 1960's and at its Lake Murray Water Treatment Plant in 1982. Chloramine is a compound composed of chorine and ammonia. It is slightly weaker than chlorine, but lasts longer in the distribution system.
Although chloramine helps to make your water safe to drink, it is toxic to aquatic organisms and must be removed from tap water prior to use in an aquarium or pond. Chloramine, like chlorine, will kill both salt and fresh water fish and other aquatic life, including Koi fish, lobster, shrimp, frogs, turtles, snails, clams and live coral.
A water-conditioning agent specifically designed to remove chloramine, or an activated carbon filter, must be used according to product instructions. If you are already using one of these products to remove chlorine, it is possible that the same product may also remove chloramine. However, you must read the product label to be sure. Chlorine removal agents that are not specifically designed to also remove chloramine could leave excess ammonia in the water. Too much ammonia could also harm fish. Pet stores and other retail outlets have sold chloramine removal products for years and have generally recommended their use. Your pet supplier should be able to provide any further guidance you may need. Be sure to give the treatment method of your choice the appropriate time to work before you add fish or other aquatic life to the water.
Yellow, rusty, or brownish colored water is usually due to flow changes in the system that stir up iron and manganese-containing sediments. There are no health-related limits for iron or manganese in drinking water. These minerals, however, can result in staining of white laundry. Items stained by washing in discolored water should not be bleached (this will set the color into the fabric). They should be washed again in clear water. Using a laundry cleaner specifically manufactured for iron removal may be helpful as well. These products are available at most laundry product retailers.
Discolored water can also be the result of in-house plumbing problems, such as the attachment of dissimilar metals like copper and galvanized pipes, or to cracked glass liners in hot water tanks. In general, these in-house discolored water problems will be characterized by a spurt of discolored water when the water is first turned on or will be limited to the hot water.
Rusty water can also occur in the system if there is a change or increase in water flow caused by water main breaks, valve operation, or fire hydrant activation. These activities dislodge small particles of rust and stir up sediments in pipes. It is a temporary condition and should clear up in a couple of hours. If possible, avoid dishwashing or laundry until the condition clears up.
If you experience ongoing discolored water for which you can find no in-house remedy, call the City of Columbia Customer Care Center at (803) 545-3300.
Earthy/musty tastes and odors that occur in drinking water can be related to several factors. These taste and odor causing substances can be very difficult to detect at the treatment facility. There are two common causes of a musty, moldy, or earthy taste or odor in the water: bacteria growing in your drain, or certain types of organisms growing in the City's water supply.
By far, the most common cause of this type of problem is the drain. Over time organic matter (such as hair, soap, and food waste) can accumulate on the walls of the drain. Bacteria can grow on these organic deposits. As the bacteria grow and multiply, they produce gases that can smell musty or moldy. These gases accumulate in the drain until the water is turned on. As the water runs down the drain, the gases are expelled into the air around the sink. It is natural to assume the bad odor is coming from the water because the smell is noticeable only when the water is on. However there is nothing wrong with the water, but the drain may need to be disinfected.
The other cause of this type of taste or odor in the water is much less common and results from certain types of algae, fungi, and bacteria growing in the water supply reservoirs. As these organisms grow and multiply, they excrete small amounts of harmless chemicals into the water that cause a musty, moldy, or earthy taste and odor. The two most common chemicals are geosmin and methylisoborneal (MIB). Although these chemicals are harmless, the human senses of taste and smell are extremely sensitive to them and can detect them in the water at concentrations as low as 5 parts per trillion (nanograms per liter). The City of Columbia manages and monitors the water in its reservoirs carefully to prevent these organisms from growing to levels that affect the taste and odor of the water, but sometimes Mother Nature wins. If an algal bloom does occur in a City reservoir, it can take several weeks to eradicate the bloom. At the treatment plant, activated carbon can be added once the problem is discovered.
Similar "stale" tastes and odors may also occur in distribution lines related to low flow situations. The remedy in this case usually involves flushing out of the affected lines by City crews. Also, anytime plumbing has been unused for a long time, the water can develop an unpleasant taste, so faucets should be run a short time to bring in fresh water. There are no adverse health effects associated with earthy/musty taste and odor substances.
Such residues may occur in showers, toilet bowls or tanks, pet bowls, bath tub toys, coffee reservoirs, cold air humidifiers-on any surface that stays moist and is not cleaned thoroughly and regularly. These are generally the result of biological growth-molds, fungus, bacteria or algae that have originated from the air or the surfaces themselves. These microbes grow well in moist areas and the water that remains in these areas has typically lost its chlorine (disinfectant) through natural reaction or volatilization. The simple remedy is to keep such areas dry and to clean them regularly with a disinfectant solution.
These can occur as a result of degradation of hot water tank dip tubes (white) or degradation of faucet gaskets, supply tubing or pipe coatings (black). If the particles are occurring due to these causes, some basic trouble-shooting may help isolate the problem: determine whether the problem occurs only in hot water piping or certain faucets.
Contact the City of Columbia Customer Care Center at (803) 545-3300 to report concerns about the taste, smell, or appearance of your water. Hydrant flushing may be required to clear lines of cloudy water due to construction or maintenance of water mains.
Drinking water as provided by public water suppliers is clarified and disinfected. It is not sterile, however. Those with severely compromised immune systems-advanced AIDS, organ transplant patients, cancer patients on chemotherapy, or those with other conditions that greatly impair the natural immune response may wish to take special precautions regarding the water they consume, such as boiling the water prior to use. To completely eliminate the possibility of any microbial exposure from water, bring water to a full rolling boil for one minute, allow it to cool, and store it in clean, refrigerated conditions. Persons with these concerns are encouraged to seek advice from their physicians.
In the event of a major interruption in water service, such as a water main break, customers may be advised to boil their water. This can happen even in properly treated public water supplies like Columbia's. When water service is interrupted and mains are depressurized, there is an increased risk that substances might be drawn into mains through seepage or cross-connections. As a result, in larger outages, systems are required to issue Boil Water Advisories until bacteriological sampling shows that the water has not been contaminated. Such sampling usually takes 24 to 48 hours to be completed once water service is restored. City of Columbia Water work's monitoring of the water in such depressurization instances has consistently shown that the water has not been contaminated.
With increased public awareness on issues related to health and infectious diseases, the Water Works department is occasionally asked whether City water could be the cause of illness. This is highly unlikely, since the City provides water that is treated to high quality standards, uses utmost care in maintaining its distribution system, and maintains adequate chlorine residuals throughout the distribution system. In response to such inquiries, however, the Water Works Department schedules on-site water testing for bacteria and chlorine (disinfectant) residuals, as well as other basic water quality parameters if the customer so desires. Call the City of Columbia Customer Care Center at (803) 545-3300 to schedule an on-site analysis.
Contact the City of Columbia Customer Care Center at (803) 545-3300 for water pressure problems.
The range of water pressure is between 40 and 120 psi (pounds per square inch).
Drinking Water Request
1136 Washington St.
Columbia, SC 29201